Help and Support > Knowledge Base > KB-WUR-240404
Windows Update V3.1 no longer works after scanning for updates on Windows Update V4
Scanning on V4 adds registry entries (ActiveX kill bits) that block the V3.1 control. Removing one registry key brings V3.1 back.
Article IDKB-WUR-240404
Applies toWindows Update Restored V3.1 and V4
PublishedApril 19, 2024
AuthorTecAdam
  Symptoms
  • After you check for updates on Windows Update Restored V4, Windows Update Restored V3.1 no longer works.
  Cause

When V4 checks for updates, it loads its ActiveX controls and adds registry entries (ActiveX kill bits) that block the older V3.1 control.

  Resolution
  1. Click Start, click Run, type regedit and click OK.
  2. Go to HKEY_LOCAL_MACHINE\SOFTWARE\Microsoft\Internet Explorer\ActiveX Compatibility.
  3. Delete the key {CEBC955E-58AF-11D2-A30A-00A0C903492B}.
  4. Close the Registry Editor and open Windows Update Restored V3.1 again.
  More information

This is not a permanent fix. The key comes back every time you check for updates on V4, so you need to repeat these steps each time.

  Related articles
Still need help? Contact us, or browse the Knowledge Base.
Link to this page: windowsupdaterestored.com/en/go.htm?p=support/kb/v31-stops-working-after-v4.htmBack to top